Manual for honeywell alarm keypad2/7/2024 ![]() Once all switches are unset, put the back cover on firmly and press the * (star) key followed by 8-0-0 on your key pad. Make sure to note which switches are set in what position before adjusting them – it’s helpful to make a pencil mark if you won’t be able to remember their original location. On some systems, this may require an additional adjustment with a small screwdriver or other tool. Once removed, locate the system’s programming switches. This will require a Phillips screwdriver to remove the security screws. Remove the back cover of the control panelīefore beginning the reset procedure, locate and remove the back cover of your control panel. Let’s go over all the different methods available to you. There are a few different ways to reset your Honeywell alarm system, and each method has its own specific instructions. It is also a great troubleshooting step if something isn’t working properly with your system. Resetting your Honeywell alarm system is a necessary step to take if you want to make changes to your system such as adding or deleting users. Once all components have been disconnected, you can proceed with resetting your system. This includes wires, plugs, and other connections that may be attached to each other. After doing this, make sure all components of your alarm system are disconnected from each other. You can disconnect the power supply by unplugging the transformer from any power source. It may be necessary to disconnect power to the security system in order to complete a code reset.īefore resetting your Honeywell Alarm System, it is important to disconnect the power supply to ensure that no electric shocks or circuits are broken during the process. If you are unable to enter a passcode, consult with your local dealer or Honeywell representative to provide assistance in resetting the code. When successful, the armed/disarmed indicator light will turn off, indicating that the system has been disarmed. This can be done by entering your passcode on the keypad and pressing the ‘Disarm’ button. Let’s take a closer look at each step in the preparation process.īefore performing a full reset on your Honeywell alarm system, it is imperative that you disarm the system first. This includes making sure your power is disconnected, identifying the make and model of your alarm system, and having your manual handy. It is important that you prepare your alarm system beforehand to ensure everything goes smoothly during the reset. ![]() Resetting your Honeywell alarm system can be a daunting task, but if you take the right steps, the whole process can be relatively simple. 2.2 Locate the reset switch and press it.2.1 Remove the back cover of the control panel.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |